|
Sullus: Try this is you haven't already. (Hehe, I can see Mal frowning now as this is going to be a repeat of something many many times.)
OK, look at your mod chip, on the side where the two wires connect. There should be a red wire coming from the top corner of the modchip, and a blue wire coming from a point on the modchip labelled "B". Take the other end of the blue wire (which you would normally connect to the chip on the Saturn's CD board) and solder it the the point labelled "A" on the modchip. Make sure you solder well so that a good connection is made, and make sure not to accidently close any other circuits. Now solder the Red wire to the 5V prong on the power supply. It should be labelled but it is usually the next to last (NEVER put it on the last prong on either side). If it isn't labaled, its best to test with a multimeter to find which prong is the 5V.
Now correctly seat the mod-chip and 21-ribbon cable into the modchip, you should be set to go. As mal said, read through the Sticky at the top of this forum... read each and every post for a complete overview. If it doesn't work with this method, post your results in the sticky and we will try to help out. Make sure to take note if regular games play, what colors the cubes are if games don't play, if the CD-Spins up, etc.
Good luck! |