Home	Forums	What's new	Resources

Mega Drive I Scart RGB Calbe

sheep64 - Feb 6, 2002

		sheep64		Feb 6, 2002
			Hi there, I got an old Mega Drive I from eBay. I only came with a RF Cable and I want to connect it to my TV via RGB like my Mega Drive 2. How must I connect the Mega Drive to the TV? My problem is, where on the Scart connector do I have to connect the Sync from the Mega Drive. And where must I connect the +5V from Mega Drive to switch the TV into RGB Mode? (is that blanking signal???) I found a scart and Mega Drive pinout at www.hardwarebook.net...

		IceDigger		Feb 6, 2002
			you don't connect sync at all. 5V go to pins 8 and 16.

		sheep64		Feb 7, 2002
			Thankx alot!! My cable is working but there´s a little problem. I have a original Sega RGB Cable for the Mega Drive 2. When I compare the color saturation of the Mega Drive 1 and the 2. The MD1 has a lot more color saturation. I think it´s TOO much. Can I reduce the color intensity by pulling the RGB channels down to ground with resistors? If yes, how much Ohm must they have?

		IceDigger		Feb 7, 2002
			in fact, you HAVE to put a 75 Ohm resistor on each of the R, G and B lines, to get the normal output level.

		sheep64		Feb 7, 2002
			Okay, Do I have to put them into the line. Hard to describe in english sorry. Sega Red ----------//--------- TV Red Or like this: (pulled to ground) Sega Red ----------------------- TV Red I GND

		IceDigger		Feb 8, 2002
			directly on each line, not pulled to ground.

		sheep64		Feb 9, 2002
			Thanks The cable is working fine now. I´m still searching the web for some info to make a RGB mod for my Master System without Sony chip. Maybe I should buy a nice Master System I

		eke-eke		Jun 12, 2002
			hi ... i just open up a sega megadrive - mastersystem scart cable (the "black box" in the middle of the cable) and i found that the circuit inside is a little more complex than just 3 resistors and that the "sync" line is used for example (there a lot of more cable connected to the scart connector, such the blanking signal") is there someone here (arakon ??? ) who could explain the purpose of this little circuit inside the scart cable ,

		SEGA_Teufel::Ger		Jun 12, 2002
			One little question from me. What resistor I need for a 32x Conversion Cable (I want to find I out by myself but my multimeter broke down).

		Arakon		Jun 12, 2002
			@eke-eke: good question. I got no clue at all. nothing more than the resistors is needed for a good rgb signal. @teufel: none. the 32x video link cable is a 1:1 cable.