Home	Forums	What's new	Resources

Gameshark reflash CD problem

berrodt - Dec 29, 2004

		berrodt		Dec 29, 2004
			First of all its great to see there is still an active Saturn community. Following the helpful discussions here, I have a successfully modded my 64pin chip / 21pin ribbon saturn with a modchip from www.consoleaccessories.com... Now, I have downloaded and burned the gameshark/PAR reflash iso image from the following thread: http://forums.segaxtreme.net/index.php?showtopic=1... I have tried to use this CD image (arflash-datelar.iso) to flash my v1.7c interact gameshark with no luck. All I get is the gameshark menus. I am not sure, but I assum the flashCD would boot with instructions/warnings, but nothing happens. All I can get is the LOADING... message if I try to "start the game without enhancements" but it seams to pause here indefinitely. I used Nero 6.6.0.3 to burn the image, this version works fine for other saturn isos I have burned to CD-R. Any help would be greatly appreciated. Thanks, Tom

		ExCyber		Dec 30, 2004
			What happens if you try to boot it without the Gameshark?

		berrodt		Dec 30, 2004
			Hello ExCyber, The first disk I burned did not boot at all. Shortly after I posted, I wrote a cue file for the iso as follows: FILE "arflash-datelar.iso" BINARY TRACK 01 MODE1/2048 INDEX 01 00:00:00 And the burned disk was loaded by the gameshark and I was presented with the press A+B+C+START option. 134 "pages" were written OK and the DONE! message appeared. However the gameshark does not boot at all now. I simply get the SEGA Enterprises splash screen and it hangs. I am using a US saturn if that is important. Unfortunately, I did not record the flash and dev IDs. They were not recognized, yet I threw caution to the wind and proceeded anyway. I don't suspect it can be salvaged? I thank you for the reply and any advice, Tom