Home	Forums	What's new	Resources

A little clarification needed

Myname - Aug 3, 2002

		Myname		Aug 3, 2002
			Following the diagram in this... thread, I need to get switches with three pins to solder to when the minute ones I bought the other day have only two. Am I correct in thinking that it must be three? If not, could anyone tell me how it is done with two? Thanks a lot

		Mike G		Aug 3, 2002
			To do the 50/60Hz and language mods with two-pin switches, just leave out the wires which are connected to the right hand side of JP2/JP4 (assuming you're following the photo in that thread). This is the +5 volt connection, but it isn't actually needed as the signal is pulled high anyway... so you really only need a SPST (two-pin) switch. Mike

		Myname		Aug 3, 2002
			Cool, so I can use the mini switches. Cheers Mike

		Myname		Aug 3, 2002
			All done! Didn't bother with the language switch though since all the protected imports I want are USA ones. Thanks again for the help. Contra: Hard Corps here I come!

		maidtina		Aug 4, 2002
			cool, that dodgy pic is still in my webspace!!! fall down before my l33t MS paint skillz. W00t

		Myname		Aug 4, 2002
			It might be dodgy but it's the clearest thing out there . Busted my LED doing the mod and can't get the bugger out to replace it. Ack