Home	Forums	What's new	Resources

Using megadrive control pads on PC.

Flakvin - Mar 27, 2002

		Flakvin	Mar 27, 2002
		Is there any way of using a Megadrive control pad on a PC. The connection on the control pad fits into COM port 1 or 2, so, there must be some way of getting windows to detect it. I would prosume this would require some sort of drivers? Or am I being totally stupid on this one? (Edited by Flakvin at 10:47 pm on Mar. 27, 2002)

		Gallstaff	Mar 27, 2002
		i think you have to re-wire something on the pad but i am not sure.

		ExCyber	Mar 27, 2002
		Yeah, you do. The serial ports aren't going to work, and you might risk frying the pad by hooking it up.

		Raijin Z	Mar 28, 2002
		There are instructions available online somewhere.... You're supposed to build an adaptor, and you only have to sacrafice extension cables instead of killing your controller's cord.

		SegaSaturnDDR	Mar 28, 2002
		capcom used to sell a pc gamepad that was exactly like a genny controller minus a start button, and they were cheap too, too bad they dont make em anymore.

		maidtina	Mar 28, 2002
		I have seen adapters that plug into he parralel port and read as a second gameport. Also i could rewire a pad to run off a PC gameport but it would need some modification, cutting solder tracks and desoldering the multiplexor. The instructions are out there, try looking at digital joystick schematics for people building arcade boxed for their mame emulators. maybee i should sell them

		Izlude	Mar 28, 2002
		This call DirectPad Pro controller. It's a special driver for parallel port and a little hardware interface to made. This works for many pads. I build it for genesis,snes and psx and it works perfectly ! see : http://www.arcadecontrols.com/Mirrors/www....el.co...