Hey, Sega Xtreme Community.
I have Recently Just did a 21 pin to 20 pin conversion for my model 1 on a Racketboy modchip.
I'm getting a few problems i did everything correctly. Ive used the new horizontal method to install the modchip on the model 1 Sega Saturn with a ribbon cable.
Ive checked for bridging with my Multimeter and im still getting these errors.
At First i got:
No Cd Rotation
No Boot up Animation
1 Yellow Sphere on the left and a Red Sphere on the right
Then I tried Reinstalling the +5v Cable on the 2 pin from the top on the power supply and got this:
No Cd Rotation
No Boot up Animation
Green Sphere on the left and yellow sphere on the right
then i tried flipping around the ribbon cable that goes inside the modchip and i got this as well:
No Cd Rotation
No Boot up animation
2 green cubes
Now Ive looked up on Sega Style's Modchip Installation Troubleshooting page and i was told to fix the signal bridging or the no power going to the mod chip problem for the 2 green cubes.
Ive Redone the wire jumping for the signal wire and resolderd the +5V cord to its place and i put it back together and i got the red sphere on the left and the Yellow sphere on the right again.
Please Help.
Thank You
Zer0-2k10 |
