Home	Forums	What's new	Resources

Problems modding my Saturn

Tuna - May 14, 2003

		Tuna		May 14, 2003
			I have a 32 pin Saturn and at first I tried soldering the blue wire to the third pin and that didn't work, then I found the A/B soldering thing on this site and now with both originals and backups it goes to the CD player screen and displays "Checking disc format" for a few seconds and then does nothing. Any suggestions?

		Alexvrb		May 14, 2003
			Maybe like you didn't clean up the solder on the 32-pin IC? You're gonna have to make sure there isn't any solder shorting (connecting) two or more of the pins on the IC. But to make sure you should remove the modchip from the equation entirely and see if it'll play originals - you could have the cable in backwards or something...

		Tuna		May 14, 2003
			I double-checked the pins, no solder. Then I took out the mod and the drive still won't spin.

		mal		May 14, 2003
			It's not a good sign that it isn't working after you've removed the mod... Are all of the cables that run to the CD board properly attached? Maybe try pulling them out and re-inserting them.

		Tuna		May 14, 2003
			I just found the problem...I broke the third pin. Can this be fixed?

		mal		May 14, 2003
			Not easily. With some very careful soldering you could, but it would be very fine work...

		Tuna		May 14, 2003
			What about trying conductive epoxy?

		Alexvrb		May 14, 2003
			Anything highly conductive should do the trick, but the problem is you have to be really careful... maybe cover the other pins with something.

		7		May 15, 2003
			you can just run a wire from the the broken pin t the chip where it goes to, its the one with 64 pins i think, just turn over the CD drive and follow where the line goes and run a wire to there